Aquanami jetKayak Instrukcja Obsługi Pobierz pdf (Strona 44)

Jet Impeller Install Procedure:

Follow the reverse steps to install the

impeller and stator. Make sure use

appropriate jet pump bearing grease

for bearings, and fill inside impeller

rubber boot. And use marine grade

rubberized silicon to seal cone during

installation, and joints between intake

duct, stator and nozzle.

Insert non-moving part of

mechanical seal into intake duct,

and insert moving part of

mechanical seal into drive shaft.

Install ride plate and heat exchange plate. Make sure the rubber seal

between jet intake duct and ride plate is in perfect condition and

perfect fit. Any leak can cause jet power loss. Use medium strength

thread locker for screw thread. Apply marine grade anti-seizure

lubricant between the screw heads and ride plates.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 82 83

AQUANAMI 1
WARNING 2
WARNING 3
SAFETY NOTICE 3
TABLE OF CONTENTS 4
AQN12345B111 5
ILLUSTRATIONS AND PROCEDURES 6
MAINTENANCE CHART 7
Product Maintenance Chart 8
PRE-SEASON CHECKS 10
PRE-SEASON CHECK LIST 11
STORAGE PROCEDURES 12
Proceed as follows: 14
Anticorrosion Treatment 15
DRAIN ENGINE COOLANT 16
DRAIN ENGINE OIL 16
DRAIN CARBURETOR FLOAT BOWL 17
Water-Air 18
LUBE ENGINE AND CARBURETOR 22
SPECIAL PROCEDURES 24
Capsized Watercraft 26
Submerged Watercraft 27
Water-Flooded Engine 27
Fuel-Flooded Engine 28
3 (cu in) 149.6 (9.2) 29
POWER PLANT SPECIFICATION 29
TROUBLE SHOOTING 31
ENGINE WILL NOT START 32
Spark plug 34
Tighten and seal the spark 34
ENGINE HARD TO START 35
Drain carburetor bowl. Drain 37
Clean and remove blockage 37
ENGINE STOPS RUNNING 38
ENGINE OVER HEAT 38
PROPULTION SYSTEM 40
Stator and Impeller 41
Intake and weed cutter 41
Propulsion System Part List: 42
Engine Assembly: 46
Engine, right view 47
Engine Part List: 48
Engine Removal Procedure: 49
Engine Install Procedure: 51
ELECTRIC SYSTEM 53
Jetkayak Electric Switches: 55
Jetnami Electric Switches: 56
Electric Part List: 57
Disconnect the 3 wires from 58
SPEED/THROTTLE CONTROL 64
Open the rubber seal. Apply 66
COOLING SYSTEM 67
Cooling System and Flow 68
Cooling System Part List: 69
EXHAUST SYSTEM 70
Flushing hose check valve 71
Flushing quick connector 71
Bilge siphon pump head 71
Exhaust System Part List: 72
FUEL SYSTEM 73
Fuel System Part List: 74
STEEING SYSTEM 75
Steering rotary parts 76
Steering rotary at joystick 76
Steering System Part List: 77
BILGE PUMP, WATER CENSOR 80
Procedure: 81
Hull Part List: 83

Komentarze do niniejszej Instrukcji

Brak uwag

Aquanami jetKayak Instrukcja Obsługi Strona 44

Komentarze do niniejszej Instrukcji